PortuguêsWelcome to Nexto Xpress’ first steps guide, your front gate to the Industry 4.0. In this guide, it will be demonstrated how to connect Nexto Xpress ...
Welcome to Nexto Xpress’ first steps guide, your front gate to the Industry 4.0. In this guide, it will be demonstrated how to connect Nexto Xpress ...
This tutorial presents the steps for inserting the LibIntegratedIoExt library into MasterTool IEC XE, in addition to configuring the function block An...
IP Change via ApplicationController`s IP address, sub-net mask and gateway changes can be performed at runtime by the PLC application using function blo...
Maintaining your CPU’s firmware up to date is of extreme importance to assure that your system works properly, as well as to grant you access to new...
In this tutorial is described the orientations and procedure ro use the Xpress as a client FTP, through the use of functions available at the librarie...
Changing application state by user programIn this tutorial are described the guidelines and procedures for change state of your PLC using the user progr...
In this tutorial is described the procedure and orientations to use five additional analong inputs on your PLC through the function block AnalogInputPro...
If you need to know more about variable declaration, use of function blocks, electrical characteristics of products, pinout of serial ports, among other...
NOTE: This tutorial was validated in version 3.20 of MasterTool. For the correct development of the tutorial below, your software version must be e...
1) IntroductionNexto Xpress controllers contains a CAN bus interface compliant with CAN 2.0A and CAN 2.0B standards (11-bit and 29-bit identifiers). The...