PortuguêsWelcome to Nexto Xpress’ first steps guide, your front gate to the Industry 4.0. In this guide, it will be demonstrated how to connect Nexto Xpress ...
Welcome to Nexto Xpress’ first steps guide, your front gate to the Industry 4.0. In this guide, it will be demonstrated how to connect Nexto Xpress ...
IP Change via ApplicationController`s IP address, sub-net mask and gateway changes can be performed at runtime by the PLC application using function blo...
Maintaining your CPU’s firmware up to date is of extreme importance to assure that your system works properly, as well as to grant you access to new...
In this tutorial is described the orientations and procedure ro use the Xpress as a client FTP, through the use of functions available at the librarie...
In this tutorial is described the procedure and orientations to use five additional analong inputs on your PLC through the function block AnalogInputPro...
NOTE: This tutorial was validated in version 3.20 of MasterTool. For the correct development of the tutorial below, your software version must be e...
1) IntroductionNexto Xpress controllers contains a CAN bus interface compliant with CAN 2.0A and CAN 2.0B standards (11-bit and 29-bit identifiers). The...
To carry out this tutorial, MasterTool software 3.12 or higher is required.1. Project creationNote that the configuration serves both the NX3003 and for...
For perform the steps this tutorial, the PLC must be in STOP mode.1. Open MasterTool IEC XE 3.11 software.2. &nbs...
The SOE (Sequence of Events) is responsible for the generation of a sequence of digital events. Through the SOE it is possible to analyze the historic b...